Flujometro Electromagnetico M2000
For general purpose detection and field verification testing.
The M2000 mag meter combines a general purpose detector with an amplifier representing the next generation of electromagnetic flow meter signal processing. This recent addition to the M-Series® family features a user-friendly, advanced design and is built for field verification testing with the use of a simple, handheld device..
The Badger Meter M-Series® M2000 is the result of years of research and field use of electromagnetic flow meter technology. Based on Faraday’s law of induction, these meters can measure almost any liquid, slurry or paste that has minimum electrical conductivity.
Designed, developed and manufactured under strict quality standards, the M-Series meter features sophisticated, processor-based signal conversion with accuracies of ±0.25 percent. The wide selection of liner and electrode materials helps ensure maximum compatibility and minimum maintenance over a long operating period.
The flow meter is a stainless steel tube lined with a non-conductive material. Outside the tube, two DC powered electromagnetic coils are positioned opposing each other. Perpendicular to these coils, two electrodes are inserted into the flow tube. Energized coils create a magnetic field across the whole diameter of the pipe.
As a conductive fluid flows through the magnetic field, a voltage is induced across the electrodes. This voltage is proportional to the average flow velocity of the fluid and is measured by the two electrodes. The M2000 amplifier receives the detector’s analog signal, amplifies that signal and converts it into digital information. At the processor level, the signal is analyzed through a series of sophisticated software algorithms. After separating the signal from electrical noise, it is converted into both analog and digital signals that are used to display rate of flow and totalization.
With no moving parts in the flow stream, there is no pressure lost. Also, accuracy is not affected by temperature, pressure, viscosity, density or flow profile. There is practically no maintenance required.
- Rating: general purpose detection
- Accuracy: ±0.20 percent
- Sizes: ¼ inch to 54 inch (DN 6 to 1400)
- Power supply: 10…36 VDC, 85-265 VAC
- AMR- and SCADA-ready outputs
- Available protocols: HART, MODBUS RTU and Profibus
- Additional kits: Store/Restore and Data Logging
Water and wastewater, well water and reclaimed water, bi-directional flow applications, chemical, pharmaceutical, and food and beverage applications.
Ver PDF con más información y detalles.