Lighten up your toolbox
Compact calibrator replaces toolbox of single function devices
- Check Continuity
Technician friendly operation
Intuitive EZ-DIAL Double Click Menu makes it easier to setup than
other multifunction calibrators. Similar to the menus as the single
function PIECAL Evolution Calibrators. Icons on the display show where to plug in the test leads.
Use it as a milliamp and voltage calibrator
Source 0.000 to 24.000 mA, 0.00 to 10.250 V dc, -20.00 to 99.999 mV and -500.00 to 999.99 mV
Read to 24.000 mA, 60.00 V dc ±99.999 mV and and ±999.99 mV
Simulate 2-Wire Transmitters
Power up transmitters & loops with the built-in 24 V power supply.
Simplify HART hookups with built-in 250 Ohm resistor
Troubleshoot loop problems
Quickly diagnose ground fault and current leakage with patented loop diagnostic technology (US Patent 7,248,058)
Calibrate directly in temperature (°C & °F)
The PIECAL 820 works with the instruments you use.
Types J, K, T, E, R, S, B, N, G, C, D, L (J DIN), U (T DIN) and P (Platinel II)
Pt 100 Ohm (3850, 3902, 3916, 3926) & 1000 Ohm (3850)
Copper 10 & 50 Ohm, Nickel 100 and 120 Ohm
Checkout flow and vibration systems
Source & read frequency to 2000 CPM (Counts-Per-Minute), 999.00
Hz, 9999.9 Hz, 9.9999 kHz & to 20.000 kHz
Troubleshoot loop & wiring problems
'Beep' out connections with the built-in continuity checker
Simulate pH probes into transmitters & analyzers
Source from 0.000 to 14.000 pH @ 25°C (77°F) corresponding to +414.12 to -414.12 mV
Measure pressure with optional pressure modules
32 modules for gauge, differential, compound and absolute pressure
Easy to read
Turn on the backlight & easily see the display in dark areas of the plant
Quickly set any three outputs plus automatic stepping & ramping
Easily set any value quickly with the adjustable "DIAL" plus store any three output settings for instant recall with the EZ-CHECK™ switch. Choose between 2, 3, 5 & 11 steps to automatically increment the output in 100%, 50%, 25% or 10% of span. Select RAMP to smoothly increase and decrease the output between Zero and Span. Set step/ramp time to match your system from 5, 6, 7, 8, 10, 15, 20, 25, 30 and 60 seconds.
Measure temperature sensors, frequency pickups, loop currents, voltage levels & pressures
Check the values of your process sensors. Instantly recall MAX and MIN values to see process variability.